Directions

1. First, activate the hand warmer 30-45 minutes ahead of time. Once the warmer is hot, shake the bottle and microwave on high for 10 seconds. (No microwave? No problem! Just attach the preheated hand warmer to the bottle an hour before your test.) The temperature strip on the bottle should display a green dot in a range of 94° – 100°F.
2. Shake the bottle once more.
3. Attach the hand warmer with tape or a rubber band to the back of the bottle opposite the temperature strip. This will provide prolonged heat, keeping the bottle temperature near 100°F for approximately five hours.
4. Finally, remember to shake the bottle again when you’re ready to use it. That’s it! (continue for use with Quick Fix)
5. Shake the Quick Fix^® Plus bottle and microwave on high for 7-10 seconds. The temperature strip should display a green dot in a range of 94° – 100°F. The synthetic urine is overheated if the bottle feels warm in your hand but does not show a reading on the temperature strip. Let it cool down gradually until you see a reading on the temperature strip. If the synthetic urine temperature is below 94°, heat again in the microwave for a few more seconds until you see the green dot on the temperature strip between 94° – 100°F.
6. Attach the hand warmer with tape or a rubber band to the back of the bottle opposite the temperature strip. This will provide prolonged heat, keeping the bottle temperature near 100°F for approximately five hours.
7. If you can’t microwave the Quick Fix^® Plus, attach the hand warmer to the bottle at least 1 hour before your test. Shake the bottle before and after heating and before pouring into a cup.

If your product remains unused, it can be reheated as needed.